Hi Everyone,
I couldn't find a previous answer that directly answers my question....
I am fitting a new Toilet. It is an Imperial close coupled model (Westminster). The waste outlet from the toilet faces the back wall of the bathroom. The waste pipe from the stack pipe is horizontal, about an inch off the floor and very near the back wall at 90 degrees to the toilet outlet to the left. The waste pipe is lower than the toilet outlet. Please see last three photos in my album.
My question is what is the best connection to use. I don't want to fit a flexi-pipe type because I want a smooth interior surface to ensure a good flow. I assume I need a 90 degree connection down then a 90 degree connection to the left with a downward slope on it. What are the alternatives. Any advice would be most welcome. Thanks. Regards, Mark.
I couldn't find a previous answer that directly answers my question....
I am fitting a new Toilet. It is an Imperial close coupled model (Westminster). The waste outlet from the toilet faces the back wall of the bathroom. The waste pipe from the stack pipe is horizontal, about an inch off the floor and very near the back wall at 90 degrees to the toilet outlet to the left. The waste pipe is lower than the toilet outlet. Please see last three photos in my album.
My question is what is the best connection to use. I don't want to fit a flexi-pipe type because I want a smooth interior surface to ensure a good flow. I assume I need a 90 degree connection down then a 90 degree connection to the left with a downward slope on it. What are the alternatives. Any advice would be most welcome. Thanks. Regards, Mark.