I need to install a new Integrated Cooker Hood in my ageing kitchen. It is to replace a broken AEG that has ben there since new. I have found a couple but the one sold on Screwfix has a negative comment that the width measurements of 605 because of proud carcase screws which would hamper installation between existing wall cupboards. The other one sold by a local appliance shop if made by CDA who I have never heard of but the brochure is massive and assume their pukka.
My question regards the instructions, which always mention fitting to the wall as well as adjacent cupboards. My existing one is screwed to the cupboard's only and has been OK for 25 years. I assume the reason or this is that the extractor is 27cm. depth and the cupboards are 32cm. depth hence a gap appears behind to keep the extractor flush at the front.
Is wall mounting essential and has anyone heard of CDA? Thanks
My question regards the instructions, which always mention fitting to the wall as well as adjacent cupboards. My existing one is screwed to the cupboard's only and has been OK for 25 years. I assume the reason or this is that the extractor is 27cm. depth and the cupboards are 32cm. depth hence a gap appears behind to keep the extractor flush at the front.
Is wall mounting essential and has anyone heard of CDA? Thanks
