This pipe has cracked and was leaking at one point (though this was when we had a blockage, seems ok now). Is it possible to repair or should I replace? Any advice is appreciated.
If you are very patient you could cut the elbow off without touching the pipe inside and then sandpaper the pipe ready for a new elbow.
There may be a way to un-weld the glue ?
If you are very patient you could cut the elbow off without touching the pipe inside and then sandpaper the pipe ready for a new elbow.
There may be a way to un-weld the glue ?
It's all solvent weld by the looks of it. Difficult one to replace in such a short run without replacing some of the section through the wall.
There are some that suggest the fitting can be heated or cut off the pipe, tried it a few times with little success, would only see it working if the joint hadn't been made properly and the ABS hadn't 'welded' together.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local