I have two pipes that need cutting and can't cut them with copper pipe cutter because they are close to the wall and you can't turn a cutter on them any ideas?
if they are scrap pipes that will never be used again, a multicutter.
the pipes will blunt the blades, but you can buy cheap ones and treat them as disposable. bimetallic or other more expensive blades will last longer but cost more. Beware, some brands of cutter use their own special design and will not fit other makes.
I'd be tempted to use a hacksaw, being careful to do it as close to right angles as possible. Then, assuming you want to end up with a gap between the 2 ends and that there's now some play in the pipe, use something like this (link):
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local