dhw problem with ideal isar 24he

[meanbean]

hi, having problem with idael isar 24 he boiler. CH ok but poor dhw. Any ideas?

 

[clf-gas]

Does the heating pipe get hot when hot tap is opened.

 

[newcareer]

i have an ideal he30 and seem to have same problem, nobody seems to know the answer to this on this forum ...maybe you should try ideal , i will phone them tomorrow

 

[clf-gas]

i have an ideal he30 and seem to have same problem, nobody seems to know the answer to this on this forum ...maybe you should try ideal , i will phone them tomorrow

Well you answer the above Question

 

[newcareer]

the heating pipe goes cold and hot

 

[newcareer]

well if you have any ideas i am listening

 

[clf-gas]

Then Its the back end of the diverter, the motor isnt pushing the rod all the way.
You have a dirty heating system and the crud is building up in the div, cuasing the pin to become very very stiff.
Strip out the div and strip down clean and grease, this will cure it, be warned though you may need a new motor for the head.

CURED

 

[swbjackson]

My idea is don't be so flipping impatient. None of the pros on the forum are paid for their advice. We are online after doing a days work. If you want an instant answer pay to have someone come round and look at your boiler. If you just want to sling abuse because no one has answered you two minutes after you've posted I doubt you will get a sensible answer.

 

[newcareer]

thanks i will try that

 

[idealnumber1]

why don't you manually push the pin in/out a few times

 

[clf-gas]

why don't you manually push the pin in/out a few times

Elaborate

 

[meanbean]

hi, got diagraphm kit and replaced. Problem gone, thanks for your input.

 

[idealnumber1]

why don't you manually push the pin in/out a few times

Elaborate

if it was the head a c with a flashing burner light would show
usually the cartridge gets blocked allowing the hot water to go down the heating flow