Elbow to tank connector

[charlie275]

This has to be a noob question, sorry.

Can the 15mm compression nut from a tank connector be removed and instead fit a 1/2" BSP elbow to create a right-angle connector?

The threads seem to match albeit a bit loose. There is no olive obviously. So for it to work would at least need PTFE tape, is that sufficient?

Compression Tank Connector 15mm

• charlie275
• 27 Apr 2022

Compression Adapting 90° Female Elbow 15mm x ½

• charlie275
• 27 Apr 2022

 

[CBW]

Is there a reason behind this? Does the existing do this? Is it for a water butt?

 

[charlie275]

It's for a CH cistern relocation. The feed ideally needs to come off at a right-angle, clipped to the shelf, and then drop about 0.5m over a 3m run. It's either this or have a short stub from the tank connector going to a compression fitting elbow.

 

[CBW]

I would use the tank connector and a spigot/Street elbow

 

[Ihavenojob]

Bent tank connector?
15mm Compression 90° Bent Tank Connector Brass Plumbing Fitting For Copper Pipe | eBay

 

[CACKATALLTRADES]

I don't really see why it would be a problem if you can wind the elbow all the way onto the tank connector (and can't just waggle it off again). It really depends on what you mean by a bit loose. They could just be at opposite ends of the manufacturing tolerances, but I believe they're nominally compatible. If it's too sloppy for comfort then try with a different tank connector. Water damage is expensive.

 

[CBW]

Bent tank connector?
15mm Compression 90° Bent Tank Connector Brass Plumbing Fitting For Copper Pipe | eBay

Doh! RtfOP - was looking for a 22mm.