I'm building a garden room but due to certain build requirements, I need to hang the joists and slope the (epdm) roof perpendicular to the front doors (side to side as you look at the building). I was going to slope the roof one way and build a small upstand to the front to hide the slope. However I'm now not sure this will look great. I'll be using firrings and the roof width will be 4.8m, would it be possible to butt the firrings through the middle and slope both ways at 2.4m, assume I'd need a 40mm to 0 on firrings either side. Would butting the osb on top of the firrings cause any issue at the butt joint when putting on the rubber? TIA
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Flat roof, dual sloped
- Thread starter Wils81
- Start date
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
