Galaxy G2 Fire Detection

[ITGURU]

Do Honeywell not have a wired Smoke detector for the galaxy G2 range? I can only seem to find wireless ones, but other manufacturers offer wired ones.

Anyone else integrated fire alarms with galaxy panels, and what have they used?

Do they have to be Honeywell models?

 

[sparkymarka]

Nope .....menvier M12 ....Texecom exodus....the menvier is programmable via dip switches for smoke / heat or combination

 

[ITGURU]

Thanks - would you know how to wire the Texecom exodus onto a honeywell panel? obviously the power + & - are easy but then have a common 0v and zone link (2 other wires to attach for the fire zone) on the board.
in the PIRs and door contacts I have resisters - are these required on the Texecom exodus or is there only 2 other wires to attach, such that when the smoke detector is activated it sends the signal to the control panel?

 

[sparkymarka]

You just put the 1k resistors in the smoke detector head ! One across the relay and the other from the relay to the alarm cable ...

 

[ITGURU]

This is the manual for it http://www.texe.com/uk/uploads/INS243-2_(Exodus_4W_Installation_Instructions)_9.pdf

I'm assuming the 2 wires for the zone would be A & B - i'm assuming there is no tamper so just need 1 resistor between a and b as part of the zone loop between the wires?

 

[sparkymarka]

yes 1k across A and B , 1k B to C ( spare terminal ) wire to A and C