gas ufh specialists - would like some advice please
- Thread starter Random46
- Start date
Bit of a trek for me I'm afraid.
M
MJGas
If its a full UFH system and no rads, There might be no blending valve. They may just have set the Temp on the boiler and locked it at a max temp. What boiler do you have OP?
It's a bit far for me too I'm afraid @Random46 There are a few guys in the Combustion chamber that are from the merseyside area but off the top of my head I cant remember who they are. If you give me a bit, when I get back in I'll tag them in the post and see if they can help unless you find someone in the mean time.
Jon
Jon
@Random46 I've asked in the CC so just waiting on anyone that may be able to help you. If nothing comes off then if you know people that have the same set up around you or friends and family know a GOOD guy then try that.
Otherwise, me or Dan could turn up if you pay for travel time, job time, accommodation and the first two dances lol.
Jon
Otherwise, me or Dan could turn up if you pay for travel time, job time, accommodation and the first two dances lol.
Jon
I'm going to the far reaches of Norfolk to help a poster here. I don't mind travelling, but I do have to run a business and support a family. 
I'm at my most charitable when SWMBO is on her summer break, but this summer is booked pretty heavily.
I'm at my most charitable when SWMBO is on her summer break, but this summer is booked pretty heavily.
haha thanks guys 
i have managed to get hold of the manufacturers who have said they would send someone out who will tell me what i need + recommend someone to do the job foc which was good of them they are coming on weds, thanks again
i have managed to get hold of the manufacturers who have said they would send someone out who will tell me what i need + recommend someone to do the job foc which was good of them they are coming on weds, thanks againjust an update, they suggested i needed the mixer pump, 2 valves to separate the rads from the ufh + however many thermostats i want... ive managed to work out which loop goes where now by process of elimination... but was also suggested i need to take up my carpet + put down special underlay as thats why i cannot feel anything through the carpeted rooms, and that it would cost around a grand in plumbing + electrical work so not so happy about it!
Underfloor heating can be an expensive thing to put right is it has been cocked up. It is well worth it when done properly.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local