- Joined
- 1 Dec 2015
- Messages
- 3
- Reaction score
- 0
- Country
Hi. I have just moved into a property that has been vacant for over 3 months. There is a halstead ace high boiler installed and this was serviced and certified in full working order during the survey.
The pressure gauge was down to zero, I have filled the system to 1.5 bar, and checked the overheat reset button.
Whenever I turn on the hot water or heating, the boiler engages (fan\pump starts, boiler fires) but then stops almost immediately afterwards and the power light flashes. If I reset the boiler, the power light stays on constantly.
What can I do to get this working?
The pressure gauge was down to zero, I have filled the system to 1.5 bar, and checked the overheat reset button.
Whenever I turn on the hot water or heating, the boiler engages (fan\pump starts, boiler fires) but then stops almost immediately afterwards and the power light flashes. If I reset the boiler, the power light stays on constantly.
What can I do to get this working?