help - Bell Box to contol panel

[gasman1987]

hi - need some help with connecting kinetic Az-teck external sounder unit to my control box. I am unsure of the make but the pcb is made by networker

the connections on the bell box are 1/tamper return 2/bell(-) trigger 3/supply 12v (+) 4/ supply 0v (-) 5/strobe (-)

the connections on control box are 1/ trg - 2/stb - 3/tr - 4/ h/o - 5/ h/o+



am i right to think that 1/ tamper goes to trg 2/ strobe goes to stb 3/ supply 12v goes to h/o+ 4/ supply ov goes to h/o - 5/ bell trigger goes to tr-

 

[sparkymarka]

control box h/o - is supply - on bell box ov
control box h/o + is supply + on bell box 12 +
control box trg is bell - on bell box
control box stb is strobe on bell box
control box tr- is tamper return on bell box



hope this helps

 

[gasman1987]

that helps a great deal mate, hopefully the alarm works because some ***** ripped my old bell box off the wall and blown the fuses inside the unit

thanks again for the help

 

[AssociatedAlarms]

The connections are correct.

Now fit the new one higher.Or go for a metal clad one, Texecom Odessy3M or Rapier 6000.
Not cheap but will not fall off like some other cheap tat.

AND USE THE BIGGEST AND LONGEST SCREWS POSSIBLE, 3 INCH 12`S ARE MY PREFERRED.