New to this folks....
Could anyone tell me what would stop the fan and the gas solenoid opening on the Biasi Garda HE 28? Basically thought the transformer may be shot (ie not producing 24vac but after applying 240vac, I can see 24vac on pins 9-10 & 10-11, so now it would seem it is and its possibly the relay not moving, so guessing there is an inhibit stopping the fan and solenoid. What is the start up sequence of these things?
The 3 lights are showing as: I - Flashing II, Flashing, III - Solid State meaning diaphram but it works fine. When I test the diaphram in good condition it moves to the next fault.... I- Flashing, II - Off, III - Flashing.......
Any ideas??
Thanks
Could anyone tell me what would stop the fan and the gas solenoid opening on the Biasi Garda HE 28? Basically thought the transformer may be shot (ie not producing 24vac but after applying 240vac, I can see 24vac on pins 9-10 & 10-11, so now it would seem it is and its possibly the relay not moving, so guessing there is an inhibit stopping the fan and solenoid. What is the start up sequence of these things?
The 3 lights are showing as: I - Flashing II, Flashing, III - Solid State meaning diaphram but it works fine. When I test the diaphram in good condition it moves to the next fault.... I- Flashing, II - Off, III - Flashing.......
Any ideas??
Thanks