Hi people,
Ive been mucking about with this dishwasher yet gain - I hate it!!
My wife comes down to the kitchen this morning and announces that the dishwasher has been running all night. So Ive removed dishwasher and taken a look underneath. The tray was full with water so I got out the wet vac and hovered it up. The source of the puddle was that the clear pipe that runs up the back of the machine and connects to the heater (or should do) had come away from the heater. I reconnected the pipe and tightened the jubilee clip (replaced heater a couple of years ago).
when running the dishwasher again it seemed to just get really hot. You could see the water boiling away at the bottom of the clear pipe. the pump for the waste pipe ran a couple of times and the tablet tray had opened but it didn't finish its cycle. 2nd and 4th lights from the left are now flashing.
Also on a slightly different note. When running the dishwasher before it packed up there was always condensation near the on/off button. Ive replaced the seal that goes around the door but this didn't seem to help. Does this point to the seal at the bottom of the door?
Any help would be most appreciated
Thanks
Mark
Ive been mucking about with this dishwasher yet gain - I hate it!!
My wife comes down to the kitchen this morning and announces that the dishwasher has been running all night. So Ive removed dishwasher and taken a look underneath. The tray was full with water so I got out the wet vac and hovered it up. The source of the puddle was that the clear pipe that runs up the back of the machine and connects to the heater (or should do) had come away from the heater. I reconnected the pipe and tightened the jubilee clip (replaced heater a couple of years ago).
when running the dishwasher again it seemed to just get really hot. You could see the water boiling away at the bottom of the clear pipe. the pump for the waste pipe ran a couple of times and the tablet tray had opened but it didn't finish its cycle. 2nd and 4th lights from the left are now flashing.
Also on a slightly different note. When running the dishwasher before it packed up there was always condensation near the on/off button. Ive replaced the seal that goes around the door but this didn't seem to help. Does this point to the seal at the bottom of the door?
Any help would be most appreciated
Thanks
Mark
