Hotpoint WMA13 washing machine

[andy fi]

Control panel PCB blew due to faulty door lock. Replaced door lock and was given a PCB from a WMA30 which I know to be working. However, my machine when turned on now will empty and refill but wont spin. The motor seemed fine before so I wonder if it is to do with the PCB?
Any advice gratefully recieved.

 

[allround]

firstly there are several different modules for the WMA range although they probably look identicle. on the module there will be a label . it will be either red , yellow , white etc etc and you need to make sure the one you fitted is the same colour lable as the one removed and from the models you mentioned i think the one you fitted will be incompatible. Secondly If you have the same module then the new one will need to be configured to your model . so first check the label colour and if all ok on that side get back to me and i will find out the configuration codes for your model and post them ..