Hi - Problems with Hotpoint WMA30
Machine will start,fills with water and starts to wash but after a few minutes machine will stop and all leds go out.
Only way to get it going is to unplug from mains and restart it,then it will do the same again but each time you restart it the time shortens before it cuts out.
Also cuts out the same on a spin program
Have checked motor brushes,look good as new.
Heater and thermistor both read ok on a meter.
Cleaned out drain sump but it was clear.
For the short time it runs everthing seems to be working fine.
Run out of ideas now,suspect it may be the control panel.
Anyone got any ideas please.
Machine will start,fills with water and starts to wash but after a few minutes machine will stop and all leds go out.
Only way to get it going is to unplug from mains and restart it,then it will do the same again but each time you restart it the time shortens before it cuts out.
Also cuts out the same on a spin program
Have checked motor brushes,look good as new.
Heater and thermistor both read ok on a meter.
Cleaned out drain sump but it was clear.
For the short time it runs everthing seems to be working fine.
Run out of ideas now,suspect it may be the control panel.
Anyone got any ideas please.