How do i programme a BG RC1 wireless thermostat?

[jeffcapes082]

hi

I have recently decorated my living room and when i removed the thermostat off of the wall i dropped it and the batteries have fallen out. I picked them up and put it to one side and now that i have finished i need to programme it again.

In the airing cupboard there is a reciever with buttons 1 and 2 one says alarm and the over one says overide. I remember seeing the guy programme it and am sure he held both buttons together and pushed the batteries into the sender and kept pressing up and down untill it picked up a signal.

I have tried to programme it myself but appear to be losing!!!

Any help apprciated

Thanks

 

[twgas]

1) pull down both battery compartments
2) turn off electric spur/unplug, wait 30 secs
3) reinstate electricity
4) press and hold button 1 then button 2, hold for 10 secs
5) reinsert left batt comp followed by right
6) turn on CH at programmer
7) if flame is showing on room stat press - button until it goes,(heating should turn off)
if no flame turn it up till it comes on.

 

[jeffcapes082]

Thanks for your help

I will try this tomorrow as i am just off to the pub but i will let you know how it goes

thanks again

 

[namsag]

Also Make sure you have the batteries in the right way, if it is the one with 2 battery compartments you must put one compartment in before the other dont push them in at same time,, lefthand first i think

 

[jeffcapes082]

Thanks guys all reprogrammed and working properly

Thanks again

If its any use I am in the stairlift trade so if you have any questions feel free to ask and i will be more than willing to help !!!!!!!!!!

 

[petit_pablo]

The battery trays need to go in right 1st then left.

 

[namsag]

cheers new it was one or the other

 

[Gas2Air]

Depends which way your looking at them