Hi,
I am fitting a new radiator and it is 120 cm edge to edge.
The existing one (will be binned), as the photo shows, it is 112 cm edge to edge.
The 15 mm copper pipes run 12 cm above to the floor to the rad as show.
The flooring is laminate, there is no way underneath, the (ground floor) crawl space is only about 10 cm(!), and I do not want to lift the floor/ drill new holes.
Clearly the piping from the floor, for the new rad, needs to go out 8 cm on one side or 4 cm on each side. I don't think there is any wiggle on the pipes.
What should I do?
Thanks
I am fitting a new radiator and it is 120 cm edge to edge.
The existing one (will be binned), as the photo shows, it is 112 cm edge to edge.
The 15 mm copper pipes run 12 cm above to the floor to the rad as show.
The flooring is laminate, there is no way underneath, the (ground floor) crawl space is only about 10 cm(!), and I do not want to lift the floor/ drill new holes.
Clearly the piping from the floor, for the new rad, needs to go out 8 cm on one side or 4 cm on each side. I don't think there is any wiggle on the pipes.
What should I do?
Thanks