I have a copper pipe going up a wall, then through it and up again. The pipe through the wall is sleeved within another pipe to protect it from corrosion and wall movement.
How do I solder both elbow fittings at each end of the pipe that goes through the wall? Part of the fitting is slightly within the wall. I could solder one end by removing it from the wall first but I still need to solder the other fitting in situ. I can't make the hole larger or deeper as there is another pipe there as sleeve.
How do the pros do it?
How do I solder both elbow fittings at each end of the pipe that goes through the wall? Part of the fitting is slightly within the wall. I could solder one end by removing it from the wall first but I still need to solder the other fitting in situ. I can't make the hole larger or deeper as there is another pipe there as sleeve.
How do the pros do it?