Going to tackle my first immersion heater change tomorrow. Other than the normal nerves before a first job
Just want to run a few stuff by the experience heads before I go ahead.
1. Turn off mains to property
2. Drain out all the taps
3. Isolate the electrics
4. Crack the nut on the immersion
5. Drain tank
6. Replace and re fill
I’ve read people saying there is a risk of the tank splitting ? That is something I really want to avoid. I would appreciate any tips and guidance
Thank you
Just want to run a few stuff by the experience heads before I go ahead.
1. Turn off mains to property
2. Drain out all the taps
3. Isolate the electrics
4. Crack the nut on the immersion
5. Drain tank
6. Replace and re fill
I’ve read people saying there is a risk of the tank splitting ? That is something I really want to avoid. I would appreciate any tips and guidance
Thank you