Hi. I'm replacing a plastic dimmer with a chrome one. Connections on the old one are black to L1, red to C. The new one has ~ instead of C, are they the same? I know I need to earth the chrome one too! Any help would be great, thanks.
Is the ~ symbol the same as C?
- Thread starter southendsteve
- Start date
That little wiggly doo-dar shows the variable ouput of the dimmer.
How many termianls in total do you have?
What are the markings at each terminal?
How many termianls in total do you have?
What are the markings at each terminal?
- Joined
- 27 Jan 2008
- Messages
- 28,388
- Reaction score
- 3,452
- Location
- Llanfair Caereinion, Nr Welshpool
- Country
In your case likely yes as it seems plain on/off but may not always be case so others reading this must be aware.
C = Common
~ = AC supply
L1, L2, L3 vary according to if a C is included.
Since you say red to C then likely that is supply wire so it will go to ~. But with two way switching this may change and I know others may read this post so warning to others C does not always = ~.
ANd beware, some dimmers (in a 2-way circuit) do not work with a regular 2-way switch at the other end.
But not in this case. you seem only to have a 1 way circuit.
But not in this case. you seem only to have a 1 way circuit.
there are three terminals in both the new and old dimmer. L1, L2 and C on the old and L1, L2 and ~ on the new plus earth. One red and one black wire and earth behind the switch.
oic, just ignore me then.
Sounds like Eric is on the right track - Red to wiggly doo-dar and black (should have red marking attached) to either L1 or L2
Sounds like Eric is on the right track - Red to wiggly doo-dar and black (should have red marking attached) to either L1 or L2
No, i think your right.
The wiggly doo-dar is not an ac symbol
it has an arrow through it, and as you say is the variable output.
Yes, the black wire has got a red marking on it. I connected it black to L1, red to squiggly thing and earth, stood well back and re-set the trip and all was ok, no instant trip, smoke or flames. The dimmer works ok. We had our wiring checked and a new consumer board installed 11 months ago and the trip switch is really sensitive so if there was a problem would it have tripped?
Steve,
All sounds good, but you really must learn the correct terminology for electrical symbols ( or as known in the trade - "wirery stuff")
Its a wiggly doo-dar, not a squiggly-thing.
C'mon, get a grip
All sounds good, but you really must learn the correct terminology for electrical symbols ( or as known in the trade - "wirery stuff")
Its a wiggly doo-dar, not a squiggly-thing.
C'mon, get a grip
Sorry bout that, I'll read up on my terinoligy for my next wiery project! Thanks for your help guys!
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
