I am fitting a standard 840 x 2100mm UPVC back door with a 715 x 915 deep UPVC window butted against it. I assume I need to ensue both are well fixed top and bottom into the brickwork. What should I do at the joint between the two to ensure a good seal / fixing?
Joining a UPVC door to UPVC window
- Thread starter fastJedi
- Start date
Sponsored Links
Run a bead of Silicone down and between the frames where they meet before you fit them together. Then just screw the 2 frames together making sure that the end of the screw isn't too long and doesn't protrude through the frame rebate at the other side.
There is usually either a steel or reinforced concrete lintel over the top of the opening. Replacement windows/doors are only usually fixed along the sides & bottom as it’s impossible to get a good fix into the lintel.fastJedi said:
Sponsored Links
Also if you get in touch with your supplier he should be able to give you a metal re-enforcing bar to go between the two. this is fixed to top and bottom and the two screwed to it.
If you don't support it you'll have to adjust the door about once a month as the window and door wobble around.
Hope thats some help??
If you don't support it you'll have to adjust the door about once a month as the window and door wobble around.
Hope thats some help??
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
