Bought and fitted Rangemaster LEIHDC70SC on the wall. Not yet made hole which will be venting out to the same wall the hood is on so it will be a small run of ducting as just need to make the hole through the cavity wall.
The manual says:
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer.
So 150mm would be preferable right? I cannot seem to find a 150mm kit off the shelf from toolstation/screwfix. The only ones I can find on screwfix are:
https://www.screwfix.com/p/manrose-cooker-hood-termination-kit-100mm/13076
https://www.screwfix.com/p/manrose-cooker-hood-termination-kit-134mm/17489
https://www.screwfix.com/p/manrose-extractor-fan-wall-fixing-kit-150mm/12523
Can anyone advise if any of the above are suitable. There is a 134mm kit that comes with a decent looking flexible metal duct, or a 150mm kit but the ducting looks the floppy variety.
Any advice?
The manual says:
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer.
So 150mm would be preferable right? I cannot seem to find a 150mm kit off the shelf from toolstation/screwfix. The only ones I can find on screwfix are:
https://www.screwfix.com/p/manrose-cooker-hood-termination-kit-100mm/13076
https://www.screwfix.com/p/manrose-cooker-hood-termination-kit-134mm/17489
https://www.screwfix.com/p/manrose-extractor-fan-wall-fixing-kit-150mm/12523
Can anyone advise if any of the above are suitable. There is a 134mm kit that comes with a decent looking flexible metal duct, or a 150mm kit but the ducting looks the floppy variety.
Any advice?