im finding I have a problem with a worktop joint in the kitchen.
There is a small gap of only about 1mm at the widest, but it's been enough to let some water in and raise each side of the worktop.
After drying out has gone down pretty much flat but I was wondering best way to fix so it doesn't happen again.
I bought some Colorfill in oak, but not used before.
Thought a smear of silicon sealant may show too much.
Also had beeswax recommended to rub in.
Help appreciated, don't want to mess it up.
There is a small gap of only about 1mm at the widest, but it's been enough to let some water in and raise each side of the worktop.
After drying out has gone down pretty much flat but I was wondering best way to fix so it doesn't happen again.
I bought some Colorfill in oak, but not used before.
Thought a smear of silicon sealant may show too much.
Also had beeswax recommended to rub in.
Help appreciated, don't want to mess it up.