Large pipe clamps

[Millwright]

Maybe Fischer Pole clamps or even scaffold clamps?

They don't do them in the required size.

 

[CountryFan]

They don't do them in the required size.

Like a Dragon then, I’m out. Doesn’t seem to be of any use what I’m looking for and posting.

 

[Millwright]

Like a Dragon then, I’m out. Doesn’t seem to be of any use what I’m looking for and posting.

Well, I believe we already went through that suggestion earlier in the thread. Thanks for suggestions though.

I've got one other line of enquiry pending from another suggestion on page 1 of the thread, a company which makes what they supply, they might be able to do something.

 

[Rodders53]

There are the exact, high quality, items required available from Clark Masts. They are expensive and the OP unwilling to pay for them.

I noted that the largest size of universal clamps from Britishpipeclamps were around the £30 mark each, plus delivery. So if they would do two bespoke sizes they'd likely be similar in cost to Clarks.

A steel fabricator / blacksmith might make a 'copy' of that universal clamp if requested in the required sizes; but again time is money and it may not be that cheap to do it.

 

[Millwright]

There are the exact, high quality, items required available from Clark Masts. They are expensive and the OP unwilling to pay for them.

I noted that the largest size of universal clamps from Britishpipeclamps were around the £30 mark each, plus delivery. So if they would do two bespoke sizes they'd likely be similar in cost to Clarks.

A steel fabricator / blacksmith might make a 'copy' of that universal clamp if requested in the required sizes; but again time is money and it may not be that cheap to do it.

Yes it was your link to Britishpipeclamps which I noticed they do an ideal clamp, just not in the size. Interestingly the skip the size I want and go much bigger. But I'll see what they say at least.

 

[robinbanks]

The side load needs to be in the centre

Why?

 

[Millwright]

Here we are

Thanks for the link to BPC Engineering, they happily custom made some

 

[CountryFan]

Here we are

Thanks for the link to BPC Engineering, they happily custom made some

Finally!!!

 

[Rodders53]

Here we are

Thanks for the link to BPC Engineering, they happily custom made some

How much did they charge? (inc P&P and VAT, of course).

 

[Millwright]

How much did they charge? (inc P&P and VAT, of course).

They didn't charge any extra to make them the size I wanted as they make them to order anyway.

 

[Scally-Ho]

Now that I've seen the clamps that you bought, would have mast coupler clamps served you well? If you had stated the mast OD several members in here would have come up with good suggestions. The tube OD would determine possible clamps; without the size everything is guess work

 

[Scally-Ho]

DELETED. . . latency caused a double posting.

 

[Millwright]

Now that I've seen the clamps that you bought, would have mast coupler clamps served you well? If you had stated the mast OD several members in here would have come up with good suggestions. The tube OD would determine possible clamps; without the size everything is guess work

On Page 1, Post 5, I did state the OD, which is why regular mast coupler clamps would not work.