im in the process of fitting a new bathroom suite. I purchased all thebits and bobs and instead of the normal bath taps Im fitting a mixer shower unit I purchased a few years ago and never got around to fitting.
Im put the taps on but have realised that water in getting through the hole where the tails go through the bath. I have used the rubber washers supplied with the kit.
Is there amyway I can stop the water like use some sortof sealant to waterproof itand stop any further water going down the gap?
Need to know asap as im back tothe job in the morning
Im put the taps on but have realised that water in getting through the hole where the tails go through the bath. I have used the rubber washers supplied with the kit.
Is there amyway I can stop the water like use some sortof sealant to waterproof itand stop any further water going down the gap?
Need to know asap as im back tothe job in the morning
