My Mira Advance Showers flow was gradually getting worse, and eventually started to drip when the shower was switched off. I ordered a new flow valve and replaced this yesterday.
After replacing the flow valve, i purged the system (for around 15 seconds) but now the shower only comes on for a short while (perhaps 10 seconds) and then switches off with the low pressure light lit.
Anyone have any ideas? I think the pressure is OK as when i press the purge button the water flow is very strong?
Is it possible the flow valve i fitted is actually faulty or is there another fault?
After replacing the flow valve, i purged the system (for around 15 seconds) but now the shower only comes on for a short while (perhaps 10 seconds) and then switches off with the low pressure light lit.
Anyone have any ideas? I think the pressure is OK as when i press the purge button the water flow is very strong?
Is it possible the flow valve i fitted is actually faulty or is there another fault?
