I want to replace the existing wooden door because it is warped and daylight can be seen through the gap.
So considering a Composite door.
The floor is Rubaon quarry tiles then a 20mm high x 110mm deep concrete cill, on which the door frame rests.
For a composite door, I am not sure what I need.
My guess is:
Cill: 150mm wide.
Threshold: 50mm low PVC-U. Better sealing than a 15mm alum threshold.
I am trying to minimise the height of cills and thresholds, but this seems the best solution.
Can anyone advise if this is the best approach or recommend an alternative?
So considering a Composite door.
The floor is Rubaon quarry tiles then a 20mm high x 110mm deep concrete cill, on which the door frame rests.
For a composite door, I am not sure what I need.
My guess is:
Cill: 150mm wide.
Threshold: 50mm low PVC-U. Better sealing than a 15mm alum threshold.
I am trying to minimise the height of cills and thresholds, but this seems the best solution.
Can anyone advise if this is the best approach or recommend an alternative?
