My hot water was coming on when not switched on, even when I removed the programmer, so I replaced the programmer (with identical one). Still had the same problem, checked in loft and zone valve was ceased. I replaced the zone valve, and when i turned fused switched spur on a little bit of smoke came out of new zone valve, and fuse blew. I checked whether the valve was open or closed and repositioned zone valve in correct position. Then when I turned the programmer on CH it worked, but as soon as I switched HW on it fused at the spur switch. Any suggestions as to what is wrong, I have been told that there may be a problem with a neutral on the PCB??
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Potterton Suprima System L
- Thread starter langleyH
- Start date
H
herebriefly
What valve did you take out, and what was it replaced with?
David
David
If you changed like for like it should work, maybe you've put a wire in the wrong place.
And it will have cost you more money on DIY than if you had got a pro in to sort it 
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
