Good to know thanks. Getting started is also one of the problems I have with mine of a similar design, it just squashes the pipe - especially the bigger pipes. I usually squeeze and twist and then when it gets started it doesn't cut square.
I am going to try and sharpen the blade and also make the starting point more pointy
Good to know thanks. Getting started is also one of the problems I have with mine of a similar design, it just squashes the pipe - especially the bigger pipes. I usually squeeze and twist and then when it gets started it doesn't cut square.
I am going to try and sharpen the blade and also make the starting point more pointy
The getting started problem is having to pull the blades open by hand even before trying to cut the pipe, then trying to get the ratchet mechanism to engage, I think it might be missing something and not prepared to put up with it any more.
The getting started problem is having to pull the blades open by hand even before trying to cut the pipe, then trying to get the ratchet mechanism to engage, I think it might be missing something and not prepared to put up with it any more.
Yes that is exactly my problem on the 40mm pipe I have to use two hands to pull it apart and then its doesn't engage the next cog, its like the cog ratchets are too far apart.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local