amateur here (obviously) ..the control unit is fed from a fused/switched spur next to it , is it necessary to switch the flat's mains right off before swapping out the probe lead..or is switching off at the spur and removing its fuse from the carrier adequate before commencing? (fwiw I would feel safer doing the former but is that a bit over the top?)..interested to see what the pros would do. thanks.
replacing temperature probe on Thermonet underfloor electric heating
- Thread starter ekon
- Start date
Sponsored Links
It is satisfactory to switch off the FCU (Fused Connector Unit - the cable is the spur) as long as everything was installed as it should be.
If you don't know that or can't check that then switch off the main switch in the consumer unit.
If you don't know that or can't check that then switch off the main switch in the consumer unit.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
