roller shutter door contact

[Bishee1999]

I have a texecom veritas panel and i want to wire a shutter door contact into it. 

I have a 4 white cable shutter door contact . Can anyone guide how to wire it up

Never done one b4. Advice will be much apreciated

 

[sparkymarka]

One pair to the zone the other to tamper in series with the other tampers..

 

[Bishee1999]

Thanx sparkymarka

All 4 cables are white how can i find 2 tamper and 2 zones cables

 

[EightyTwo]

If it's new, there should be some kind of labeling like a paper label saying SUPERVISED LOOP around the tamper pair.

If it's "pre-enjoyed", you'll need some way of measuring continuity like a multimeter or wiring to a zone and checking the state on the keypad:- two wires are permanently joined together (the supervised loop or tamper pair) and the other two are open circuit until the magnet is over the contact, when they become short circuit.

 

[sparkymarka]

Two are normally pre stripped at the end if it's a cqr roller shutter that's one pair.

 

[Bishee1999]

yes 2 are stripped and they are a pair after a continuity check

thanks