Hi all i have been to the previous posts to make sure my problem has not been covered i cant see that it has been, ok here is the setup.
I have just installed the ts1850 shower the tank is about 1.8 meter above the shower head, before i connected to the shower i run both hot and cold over the bath and got a fair amount of pressure from both but when i connected to the shower body and turned it on the pressure is rather bad, i have not installed any of the restricters and have only put in the filters,
inside the eblows that conect the the pipes to the shower body are two plastic fittings i assume these are non return valves so
1 can they be removed if so how do you get the sods out
2 what other reason might there be for the pressure droping as it gose through the body
3 i have tried to run without shower head but it is stiil low pressure coming from the hose
Can anybody please give me some help
Thanks
I have just installed the ts1850 shower the tank is about 1.8 meter above the shower head, before i connected to the shower i run both hot and cold over the bath and got a fair amount of pressure from both but when i connected to the shower body and turned it on the pressure is rather bad, i have not installed any of the restricters and have only put in the filters,
inside the eblows that conect the the pipes to the shower body are two plastic fittings i assume these are non return valves so
1 can they be removed if so how do you get the sods out
2 what other reason might there be for the pressure droping as it gose through the body
3 i have tried to run without shower head but it is stiil low pressure coming from the hose
Can anybody please give me some help
Thanks