I've called glowworm, read the manual, checked google and here, it basically seems to be a faulty PCB or ingition unit?
Everything else is working (pump etc) on the 6 year old boiler and it's practically in new condition as I haven't used the flat much. It all sounds normal, just no ignition and flame.
It stopped working after a short powercut in our area, not sure if that was the cause or not, but it was the same day.
The water pressure is good, I increased it to 1.5 bar from 1 bar, no difference.
Before I fork out cash for a PCB and ignition unit, is there anything I can do to narrow it down to one or the other?
Thanks
Everything else is working (pump etc) on the 6 year old boiler and it's practically in new condition as I haven't used the flat much. It all sounds normal, just no ignition and flame.
It stopped working after a short powercut in our area, not sure if that was the cause or not, but it was the same day.
The water pressure is good, I increased it to 1.5 bar from 1 bar, no difference.
Before I fork out cash for a PCB and ignition unit, is there anything I can do to narrow it down to one or the other?
Thanks
