Hi guys, a bit of advice would be much appreciated.
My shower control, triton?
Is starting to play up, not closing properly and leaking. Having to force it shut.
It is 28 years old, so been a good- un!
I don’t know the model, and was under the impression it is ceramic cartridge?
However, I stripped it down this morning and if it is a cartridge, it’s well and truly stuck.
As it’s so old , I obviously would like to replace the cartridge for simplicity , rather than change the complete unit? If I can get the old one out?
The inlet pipes are 125 mm apart, new ones are 150 mm! Centre to centre. Half inch inlet fittings
Not sure how I could fit a new one, no wiggle room of pipes, and tiled up to unit. Do they do smaller elbows?
I ‘ve uploaded a few pics.
Any advice would be welcome, it’s wall mounted, not inset.
Cheers
My shower control, triton?
Is starting to play up, not closing properly and leaking. Having to force it shut.
It is 28 years old, so been a good- un!
I don’t know the model, and was under the impression it is ceramic cartridge?
However, I stripped it down this morning and if it is a cartridge, it’s well and truly stuck.
As it’s so old , I obviously would like to replace the cartridge for simplicity , rather than change the complete unit? If I can get the old one out?
The inlet pipes are 125 mm apart, new ones are 150 mm! Centre to centre. Half inch inlet fittings
Not sure how I could fit a new one, no wiggle room of pipes, and tiled up to unit. Do they do smaller elbows?
I ‘ve uploaded a few pics.
Any advice would be welcome, it’s wall mounted, not inset.
Cheers
