Hi all
Just looking for advice. I've had an electrician do a bit of wiring for me including updating fuseboard, replacing switch for immersion heater with 24hr timer, wiring in a spur for shower pump and point and points for shaver socket in bathroom.
The immersion heater is my only source of hot water and located in the airing cupboard next door to the bathroom. The electrician has put a fused timer for the immersion heater and adjacent to that a fused switch for pump (sharing the IH supply?) The wire then goes out of that up to another switch for shaver point and terminates the other side of the wall in the bathroom.
The immersion is then connected to the fuse board RCD protected.
There is a 13amp fuse in the timer switch for IH and another 13 amp for shower pump switch. From what I've been reading this sounds a bit dodgey? The electrician is fully certified, listed on NICEIC website etc, but has got me worrying about what to do if wrong.
Just looking for advice. I've had an electrician do a bit of wiring for me including updating fuseboard, replacing switch for immersion heater with 24hr timer, wiring in a spur for shower pump and point and points for shaver socket in bathroom.
The immersion heater is my only source of hot water and located in the airing cupboard next door to the bathroom. The electrician has put a fused timer for the immersion heater and adjacent to that a fused switch for pump (sharing the IH supply?) The wire then goes out of that up to another switch for shaver point and terminates the other side of the wall in the bathroom.
The immersion is then connected to the fuse board RCD protected.
There is a 13amp fuse in the timer switch for IH and another 13 amp for shower pump switch. From what I've been reading this sounds a bit dodgey? The electrician is fully certified, listed on NICEIC website etc, but has got me worrying about what to do if wrong.