Smeg P775 only 2 out 5 elements working - wiring error?

[aberkeley]

Hi,
I just installed a Smeg p775 wide hob and only the dual burner hobs light up, the 3 single burners dont. I am wondering if its a wiring fault. The diagram at the base gives 3 otpions normal 240v, 340v and 240 3 phase. i am using normal 240v

The connection diagram looks like the following


1 2 3 4 Earth
o---o o---o
L1 N1 (N1 is below 4)

I have the wiring going into 1, 4 and earth. The 3 to 4 neutral has a piece of metal under it acting as a bridge but 1 and 2 dont, yet the diagram would seem to suggest it should have. Could this be the reason i only have 2 burners working - do i need to find someway to bridge 1 and 2?

Any advice would be greatly appreciated

Ant[/list][/list]

 

[tiredengineer]

That's your problem. Link the L1 and L2 and it should work.


Unplug your appliance before working on it.

 

[aberkeley]

cheers for the reply, will give it a shot after christmas cooking - just in case - what do you suggest i link it with?

 

[tiredengineer]

Use a piece of the cable used to wire it in.


Unplug your appliance before working on it