Working on a cxi ultracom 24, my problem is the fault f9, I have 1.8 bar showing when I reset it, when the boiler starts up again Im sure I hear the divert vavle motor back and fore, but the fan does not run for the pre heat, after about a minute I get f9, had a faulty pump onces before and the boiler was still firering then locking out on f5, any idears or ways to check, many thanks
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Ultracom 24
- Thread starter blacknesh
- Start date
Will try that in the morning, also gonna ring Glowworm technical, bit worried because its showing 1.8 but ain pre heating
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
