Undoing philmac

[23vc]

I’ve got a philmac connector which converts lead to mdpe 25mm. I fitted it about 7 years ago. I need to undo the mdpe side in order to take the pipe out, duct it then put it back in.
I recall these fittings being pretty good and don’t anticipate any problem with reassembling? but any views welcome. Thanks

 

[Exedon]

Should have no problems just keep everything clean as you reassemble.

 

[23vc]

Thanks, I assume the nut will stay on the pipe and come off the fitting like a compression fitting? Can’t really remember how they work

 

[Exedon]

Totally takes to bits if required maybe take a pic to reassemble correctly?.

 

[polesapart]

IIRC these Philmacs have a "grab" ring that digs into the pipe.

Whatever you do don't push this ring further onto the MDPE -it's one way only!

 

[23vc]

All done, worked a treat and dry as a bone. Cheers both