unvented HW cylinder overflow

Status
Not open for further replies.
Joined
9 Jun 2014
Messages
1,188
Reaction score
27
Location
Yorkshire
Country
United Kingdom
I am going to use 22mm copper for the over flow on my unvented hot water tank.

Can i run this out into a gutter ? Outside where the over flow will go there is a large flat roof which you can walk on. It would be easy to just continue the 22mm copper along this flat roof and deposit into the gutter, but this might not be ok.

Or can the over flow go into my soil pipe running out through this back room ?
 
Sponsored Links
Do you mean the discharge pipework from the unvented cylinder?

A G3 qualified person would know what is and what isn't acceptable. This is NOT a diy job.

I have to agree. If you were competent you would not be asking such a basic question.

Mod
 
Last edited by a moderator:

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Status
Not open for further replies.
Sponsored Links
Back
Top