ventilation in newly floored loft

Joined
22 Nov 2012
Messages
3
Reaction score
0
Location
Glasgow
Country
United Kingdom
i have recently floored my loft in december 2012 and have noticed white mould has formed on the roof of the loft etc.the flooring was left a good 6 inch+ away from the eves on both sides and i have taken up the edge cuts of chipboard to allow more air circulation to rise from the eves since i first noticed the mould growth.i have also left the window slightly open to provide an adaquate amount of air untill i get vents fitted.the skylight window was always condensated and since i have started to leave it open the condensation has gone.the mould only started after the chipboard was layed obviously preventing the air from rising from the eves above the floor but not sure if the eves will ventilate the whole loft now flooring is layed. i have wiped most of the mould off with a cloth and mould killer spray but have been told by builders that it will need to be sprayed professionally in order to kill the mould completely......could anyone inform me if this would be necessary? with regards to getting vents fitted i have a gable end wall at the far side of the loft as well as a small room in the loft which also has an exterior wall.the small room had more mould growth because there is less ventilation and was thinkin of putting two vents on gable end wall and one in the other wall in the small room in loft.could anyone inform me what type of vents should i get fitted wall vents or roof vents through the roof slates and can both be done or just one way or the other ie wall or roof or both? shouldve got the vents fitted before floor was laid but windows acting as a vent in the meantime.....any advice would be truly appreciated!!
 
Sponsored Links
The mould has appeared because you have introduced a ventilation problem by blocking the eaves, now removing the blockage, the problem should stop, as air can circulate.
Remove the mould by first using warm soapy water on it, then using diluted bleach about 15% bleach to water, then wipe bleach away and dry area.
No need for specialised sprays providing you catch it all.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top