Have Trevi Boost installed seven years. Works well but for occaisional failures. Sometimes due to limescale but even when cleaned fails to pull hot water. Eventually responds to removal, replacement of booster cartridge and/or removal of head, lowering of hose to floor. Suddenly kicks back to life. All supply conditions OK. Anybody have any ideas?
venturi showers
- Thread starter chrisrorke
- Start date
I dont do that much with showers but seeing as no one else has answered here's what springs to mind
Fit a water softener
Does it have filters on inlet .
Is it plumbed in correctly @ cylinder could be sucking in air at vent as having to lower it suggests airlock
Contact manufacturer for further advice on
Freephone: 0800 590 203
Fit a water softener
Does it have filters on inlet .
Is it plumbed in correctly @ cylinder
could be sucking in air at vent as having to lower it suggests airlock Contact manufacturer for further advice on
Freephone: 0800 590 203
Almost certainly an air lock. Fit a Surrey flange (about £15) - a pipe that's inserted in the top of the h/w tank that draws water from deeper down the tank below the air that forms in the top.
Or turn down the thermostat if your water is hotter than 85 degrees.
Or turn down the thermostat if your water is hotter than 85 degrees.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
