Dear All,
Just to let you know I changed the main PCB this morning and once set up worked perfectly, ramping up to 10mbar and staying there until temperature on the potentiometer dial reached, then modulating down as it should.
Thanks for all your advice.
A real shame that I couldn't diagnose this through a physical test (hate being a part changer!!!). If anyone can point me in the direction to learn more about PCB configuration i'd appreciate it.
Tony - I have emailed admin again to get onto the CC forum but no joy, i'll keep trying.
Thanks again,
Kal
Just to let you know I changed the main PCB this morning and once set up worked perfectly, ramping up to 10mbar and staying there until temperature on the potentiometer dial reached, then modulating down as it should.
Thanks for all your advice.
A real shame that I couldn't diagnose this through a physical test (hate being a part changer!!!). If anyone can point me in the direction to learn more about PCB configuration i'd appreciate it.
Tony - I have emailed admin again to get onto the CC forum but no joy, i'll keep trying.
Thanks again,
Kal