I need to slightly move a built in oven and the layout under the worksurface means it would be very much easier to surface mount the connectors for the oven and hob ignition. This is to be a "temporary" arrangement until the kitchen is replaced next year. Is there anything in the regs that says I have to flush mount the connectors (perhaps because of heat damage?). The Connector is currently a flush mount standard cooker connector with plastic blank with bottom exit over it, and the way it has been chased into the wall looks like it will easily come out to be re-routed about 100mm higher to clear the oven. The oven is a single oven.
Wiring behind built in oven
- Thread starter john4468
- Start date
Sponsored Links
There is nothing I have seen in the regs to stop you surface mounting the service point.
Except of course Part P Building regs
Except of course Part P Building regs
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
