Have picked this up from screwfix because I'm fed up with the noise the gas makes turning on in the morning, figured I'd get some cheap rates lecky on the immersion heater instead...
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=101338&ts=01115&id=17981
There is a big wire going from a red switch box to the immersion heater and its currently in the off position. I figure I snip the wire and wire in the timer (rated for 16A). But the wiring diagram is a bit confusing. Its a single power wire I'm looking to cut. The timer has a solid link between com and L and I can't work out where the other wires should be.
Guys, don't fail me. I'm consulting you before a) Readers digest DIY manual and b) the father in law. I have a lot of faith
(no part Ps please)
Cheers.
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=101338&ts=01115&id=17981
There is a big wire going from a red switch box to the immersion heater and its currently in the off position. I figure I snip the wire and wire in the timer (rated for 16A). But the wiring diagram is a bit confusing. Its a single power wire I'm looking to cut. The timer has a solid link between com and L and I can't work out where the other wires should be.
Guys, don't fail me. I'm consulting you before a) Readers digest DIY manual and b) the father in law. I have a lot of faith
(no part Ps please)
Cheers.