Wiring in underfloor heating - Heatmiser UH4

Joined
17 Sep 2004
Messages
53
Reaction score
1
Country
United Kingdom
I'm wiring in a wet underfloor system already laid under concrete, to connect to a new Baxi combi.
All good, except that the wiring instructions for the Heatmiser UH4 are a scant.
I've worked out the thermostats, actuators, mains in, and ufh pump.
The plumber put in a Honeywell 2 port motorised valve, and I'm assuming this is what Heatmiser are calling Boiler Enable?
On the wiring diagram, though, it says "LS AND LR IS VOLT FREE", but the Honeywell valve has 5 wires, not the 3 on the Heatmiser wiring diagram.
Any thoughts, please?
 
Sponsored Links
What other heating do you have?
Do you have other valves and/or pumps?

As for your 3 wires and 5 wires query, the diagram shows the valve :

upload_2019-11-9_17-5-28.png


but I don't know if that is an advisable method.

Volt-free is a daft name. It just means that the terminals are not connected to anything else so you can use any voltage on them.
 
Ahhh. Thanks for that.
No, no other heating source(s). Just the u/f heating.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top