Wooden worktop joints

Joined
18 Jan 2006
Messages
428
Reaction score
7
Location
Cumbria
Country
United Kingdom
I want to replace current laminate worktops with wooden ones. I am going to fit square edge worktop to simplify the corner joints. Has anyone felt the need to put a small radius or chamfer on the worktop top edge after fitting?
 
Last edited:
Never done it but I would guess it looks better and may prevent the corners getting chipped.
 
Fair enough. I might not feel the need to do it either. Initially I had wondered whether some people might run a router around the worktops to put on a small chamfer. However, considering this would be done after a lot of work had been put in fitting the worktops, there is a small risk that something could go wrong so I would probably just take off the sharp edge by hand.
 
definitely take the sharp edge off mate, just a light pass with a block plane or a 180-grit sanding block to ease the edge. dead-square 90 degree edges on solid timber chip really easily if a mug or pan bangs against them, and it feels much easier on your wrists when you're leaning over it. just keep it subtle and give it a good coat of oil straight after.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top