Not been very lucky with the above boiler and supposed to be one of the best for the money I paid for.
Fitted Jan 2019, just before the year warrant expires the boiler start leaking around the heater exchange and was repaired by Worcester engineer under warranty.
Today DHW problem, CH is fine, open cold tap boiler fire up as normal i can see temp going up on the front display DHW temp is set to 50 degree, but burner are on till it reaches 90 degree and then stops. If tap is left open the burner will fire again when temperature goes down to 60 degree and stops again at 90 degrees and same cycle is repeated again.
Any idea what is going on ? why is'n it stopping at the preset temperature of 50 degree ?
No error on display
Fitted Jan 2019, just before the year warrant expires the boiler start leaking around the heater exchange and was repaired by Worcester engineer under warranty.
Today DHW problem, CH is fine, open cold tap boiler fire up as normal i can see temp going up on the front display DHW temp is set to 50 degree, but burner are on till it reaches 90 degree and then stops. If tap is left open the burner will fire again when temperature goes down to 60 degree and stops again at 90 degrees and same cycle is repeated again.
Any idea what is going on ? why is'n it stopping at the preset temperature of 50 degree ?
No error on display