Updated: E51: Motor power triac short-circuited
Well until today its been a great machine.
It tripped the rcd two min into the 40 degree cycle, turned it back on and the display was showing 1.23 of program left with start/pause button flashing and no response if you pushed it.
I've unplugged for 10 min and door unlocks/locks fine, manually drained and checked the filter. It seems its just stuck at the start/pause flashing.
Before I call out an engineer any diag steps I can take or ways I can get error codes out?
Many thanks in anticipation.
NB. this does have an LCD
Well until today its been a great machine.
It tripped the rcd two min into the 40 degree cycle, turned it back on and the display was showing 1.23 of program left with start/pause button flashing and no response if you pushed it.
I've unplugged for 10 min and door unlocks/locks fine, manually drained and checked the filter. It seems its just stuck at the start/pause flashing.
Before I call out an engineer any diag steps I can take or ways I can get error codes out?
Many thanks in anticipation.
NB. this does have an LCD