All system is set to factory settings. For some reason movement detected by PIR causing alarm without 20 second delay. What I made wrong?
Do not have magnetic contacts and do not want to use it.
You need to set a device as an entry device. If its going to be a pir then you have to change its settings..
Go to the menu via . . . PR . . .code . . ..tick
Then choose the 'device' menu underneath walk test.
scroll down to 'edit device' and press tick.
You will now see a list of your enrolled devices.
put the cursor next to the one which is going to be your entry sensor
Now press tick and change the first attribute to 'Entry' (It will currently be set to 'burglar' press tick again and again and again until you see the list of devices again.
Now backspace out of the menu till it says Alarm Off.
Zone Type List
Burglar
• When the system is in home or away armed mode and a burglar device is triggered, a burglar alarm will be activated immediately.
• A device set to burglar will not trigger an alarm during entry or exit delay periods.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local