I've replaced my current bath outlet and overflow with a new kit. It is a tight fit, as there is very little (if any) clearance between the new pipe and the concrete floor.
There are a few odd leaks, not much water comes out.
As the area is so tight it is difficult to get a good coverage of silicon in there, so I basicaly have to get in what I can.
Would I be better to use PTFE tape first on the screw fittings (plastic) and then use silicon where I can? I am conscious that a messy silicon job will lead to leaks in the future.
Thanks
Robert
There are a few odd leaks, not much water comes out.
As the area is so tight it is difficult to get a good coverage of silicon in there, so I basicaly have to get in what I can.
Would I be better to use PTFE tape first on the screw fittings (plastic) and then use silicon where I can? I am conscious that a messy silicon job will lead to leaks in the future.
Thanks
Robert